1. Switch on the player with no dvd inside
2. Using the remote control, key in following: Setup, Next, Prev, Next, Prev.
3. In the upper right corner should you see a small menue (if not try do key Next, Prev, Next, Prev at the player not using the remote control!!!)
4. With up and donw you can switch between the entries, and with left, right you can change them.
5.change your REGION CODE with left, right too 255 and it will be set to region free, or to any requied number!
6. change the setting 3001 and 4001 to 3000 and 4000 to set Macrovision 3 and 4 will be tunred off
7.If there is 5001 change to 5000 to enable VCD playback.
If you are unsuccesfull with the above code then it may be worth trying one of the resources below.
Please confirm the code worked for you by leaving a testimonial with your thoughts on how easy or hard it was. This will improve our service. Please leave a Testimonial.
