<
1. Turn on your dvd player
2. Open the tray
3. Press the stop button on your remote
4. Enter 1999 using the remote
A menu will pop up.
5. Select the region code using the remote (set it to ALL)
6. Confirm it, using enter
7.Leave the menu using the return button on your remote
8. Close the tray
Or
1. Turn on the DVD player.
2. Open the tray.
3. Enter 2 0 1 1 (no menu will pop up)
4. Enter the region number you'd like to use (0 for region-free)
5. "SET OK" will appear onscreen if the code worked properly.
Or
Turn on your DVD player
Open the tray
On the remote, press INTRO
Press on the remote : 2,0,1,1
Press 0 for region free, 1 for region 1, 2 for region 2 etc....
You will see on screen "SET OK"
This will hack your DVD player temporarily, you have to repeat the procedure each time you want to watch a movie...
Or
Turn on your DVD player
Open the tray <--- pay attention, tray MUST be open
On the remote, press INTRO (green button at the bottom)
Press on the remote : 2,0,1,1 <-- Do this SLOWLY, like 1-2 second pause between numbers, otherwise it doesnt get the code)
Its still not going to give you any confirmation yet, so don't expect a menu or anything
Press 0 for region free, 1 for region 1, 2 for region 2 etc....
You will see on screen "SET OK" <- this is the only confirmation you get
If you are unsuccesfull with the above code then it may be worth trying one of the resources below.Please confirm the code worked for you by leaving a testimonial with your thoughts on how easy or hard it was. This will improve our service. Please leave a Testimonial.
